Riverstone Networks WICT1-12 - Manual (Page 714)

31-10 Riverstone Networks RS Switch Router User Guide Release 8.0
Port-level Rate Limiting Service Configuration
31.5 PORT-LEVEL RATE LIMITING
Note Port-level rate limiting is not yet supported by Service.
Use a port-level rate limiting policy if incoming or outgoing traffic on a particular port needs to be rate limited. Unlike
other types of rate limiting policies, do not specify an ACL when defining this type of policy. Port-level rate limiting
policies do not need to be applied to an interface and they take effect when they are created.
To configure port-level rate limiting policies for input ports, enable the aggregate rate limiting mode on the line card
Do not enable the aggregate rate limiting mode to configure a policy to rate limit outgoing traffic. Configure port-level
rate limiting policies on output ports in either the per-flow or aggregate rate limiting modes.
Note For output port policies, the only action to specify if traffic exceeds the specified
rate is to drop packets.
When using output port-level policies, all types of outgoing traffic will be rate limited, including control traffic. To
prevent the rate limiting of control traffic, use the
rate-limit port-level slot ignore-control-priority
command.
31.6 SERVICE CONFIGURATION EXAMPLES
31.6.1 Applying a Service to Multiple Servers
The configuration example in Figure 31-2 shows how easily a network can be configured for aggregate rate limiting
using a
service
aggregate1. S1 through S4 can be rate limited using one service applied to QAInterface1.
Figure 31-2 Configuration Example: Applying a Service to Multiple Servers
S1
10.9.2.1 S2
10.9.2.2
S3
10.9.2.3 S4
10.9.2.4
R1
10.9.1.1
QAInterface1
aggregate of flows
aggregate of flows
aggregate of flows
aggregate of flows
Internet