Riverstone Networks WICT1-12 - Manual (Page 364)

17-56 Riverstone Networks RS Switch Router User Guide Release 8.0
Configuring L3 Label Switched Paths MPLS Configuration
The following is the configuration for R3:
rsvp add interface R2toR3
rsvp start
! Configure VLAN
vlan create MSOPROVISIONING port-based id 100
vlan add ports et.3.1 to MSOPROVISIONING
! Configure interfaces
interface create ip R3toR2 address-netmask 220.1.1.1/16 port gi.12.1
interface create ip MSOPROVISIONING address-netmask 150.10.1.13/16 vlan MSOPROVISIONING
interface add ip lo0 address-netmask 3.3.3.3/16
! Configure OSPF
ip-router global set router-id 3.3.3.3
ip-router global set install-lsp-routes on
ospf create area backbone
ospf add interface R3toR2 to-area backbone
ospf add stub-host 3.3.3.3 to-area backbone cost 10
ospf add interface MSOPROVISIONING to-area backbone
ospf start
! Configure MPLS
mpls add interface R3toR2
! Create explicit path dp.1.2
mpls create path dp1.2 num-hops 3
mpls set path dp1.2 hop 1 ip-addr 220.1.1.1 type strict
mpls set path dp1.2 hop 2 ip-addr 220.1.1.2 type strict
mpls set path dp1.2 hop 3 ip-addr 210.1.1.1 type strict
! Create LSP for DHCP server provisioning
mpls create label-switched-path dynamic1.2MSO to 1.1.1.1 no-cspf
mpls set label-switched-path dynamic1.2MSO primary dp1.2
mpls create policy MSOMANAGEMENT.2 dst-ipaddr-mask 160.10.0.0/16
mpls create policy MSOCPEDHCP68 src-port 68 src-ipaddr-mask 150.10.0.0/16
mpls create policy MSOCPEDHCP67 src-port 67 src-ipaddr-mask 150.10.0.0/16
mpls set label-switched-path dynamic1.2MSO policy MSOMANAGEMENT.2
mpls set label-switched-path dynamic1.2MSO policy MSOCPEDHCP68
mpls set label-switched-path dynamic1.2MSO policy MSOCPEDHCP67
! Create LSP for AOL ISP
mpls create label-switched-path dynamic2.2AOL to 1.1.1.1 no-cspf
mpls create policy AOL11.2 dst-ipaddr-mask 160.11.0.0/16