Riverstone Networks WICT1-12 - Manual (Page 353)

Riverstone Networks RS Switch Router User Guide Release 8.0 17-45
MPLS Configuration Configuring L3 Label Switched Paths
The following is an example of the output of the
mpls show label-switched-paths d1
command issued at R1.
Note that the state of LSP ‘d1’ is “Up” and the label value 17 is assigned to outgoing packets on this LSP.
The following is an example of the output of the
mpls show label-switched-paths d1 verbose
command
issued at R1. Note the lines that are shown in bold: the explicit path ‘dp1’ is the primary path for LSP ‘d1’ and is
currently up and active, while the explicit path ‘dp21’ is the secondary path and is up but not active.
R1# mpls show label-switched-paths d1
Ingress LSP:
LSPname To From State LabelIn LabelOut
d1 3.3.3.3 1.1.1.1 Up - 17
R1# mpls show label-switched-paths d1 verbose
Label-Switched-Path: d1
to: 3.3.3.32 from: 1.1.1.1
state: Up lsp-id: 0x9
proto: <rsvp> protection: primary
setup-pri: 7 hold-pri: 0
attributes: <POLICY PRI SEC>
Protection-Path "dp1": <Active, Primary>
State: Up lsp-id: 0x1000001
attributes: <>
Path-Signalling-Parameters:
attributes: <STANDBY NO-CSPF>
inherited-attributes:
retry-limit: 5000 retry-int: 3 sec.
retry-count: 5000 next_retry_int: 600 sec.
bps: 0 preference: 7
hop-limit: 255 opt-int: 0 sec.
ott-index: 3 ref-count: 1
mtu: 0
explicit-path: dp1 num-hops: 4
200.135.89.73 - strict
200.135.89.76 - strict
201.135.89.130 - strict
201.135.89.197 - strict
Protection-Path "dp2l": <Secondary>
State: Up lsp-id: 0x1000002
attributes: <>
Path-Signalling-Parameters:
attributes: <STANDBY ADAPTIVE NO-CSPF>
inherited-attributes:
retry-limit: 5000 retry-int: 3 sec.
retry-count: 5000 next_retry_int: 600 sec.
bps: 0 preference: 7