Riverstone Networks WICT1-12 - Manual (Page 359)

Riverstone Networks RS Switch Router User Guide Release 8.0 17-51
MPLS Configuration Configuring L3 Label Switched Paths
R1 is the transit LSR for the LSPs from R3 to R6 and from R6 to R3. The following is the configuration for R1:
! Configure interfaces
interface create ip rt1-rt3.mp address-netmask 113.2.2.1/24 port gi.3.2
interface create ip rt1-rt6.mp2 address-netmask 116.3.3.1/24 port gi.3.1
interface add ip lo0 address-netmask 1.1.1.1/32
! Configure OSPF
ip-router global set router-id 1.1.1.1
ospf create area backbone
ospf add stub-host 1.1.1.1 to-area backbone cost 10
ospf add interface rt1-rt3.mp to-area backbone
ospf add interface rt1-rt6.mp2 to-area backbone
ospf start
! Enable and start MPLS and LDP on interfaces to R3 and R6
mpls add interface rt1-rt6.mp2
mpls add interface rt1-rt3.mp
mpls start
ldp add interface rt1-rt3.mp
ldp add interface rt1-rt6.mp2
ldp start