Riverstone Networks WICT1-12 - Manual (Page 387)

Riverstone Networks RS Switch Router User Guide Release 8.0 17-79
MPLS Configuration Configuring L2 Tunnels
R6 is a transit LSR with interfaces to R1 and R5. The following is the configuration for R6:
! Configure LDP
ldp add interface lo0
ldp add remote-peer 111.1.1.1
adds R1 as LDP peer
ldp add remote-peer 111.1.1.3
adds R3 as LDP peer
ldp add l2-fec vlan 100 to-peer 111.1.1.3
send VLAN 100 mapping to R3
ldp add l2-fec vlan 200 to-peer 111.1.1.3
send VLAN 200 mapping to R3
ldp add l2-fec vlan 100 to-peer 111.1.1.1
send VLAN 100 mapping to R1
ldp add l2-fec vlan 200 to-peer 111.1.1.1
send VLAN 200 mapping to R1
ldp start
! Configure interfaces to R1 and R5
vlan create ip_signal ip id 12
vlan add ports gi.4.1,gi.5.1 to ip_signal
interface create ip to_rs1 address-netmask 201.1.1.2/16 port gi.4.2
interface create ip to_rs5 address-netmask 220.1.1.1/16 vlan ip_signal
interface add ip lo0 address-netmask 111.1.1.6/32
! Configure OSPF
ip-router global set router-id 111.1.1.6
ospf create area backbone
ospf add interface all to-area backbone
ospf add stub-host 111.1.1.6 to-area backbone cost 5
ospf start
! Configure MPLS
mpls add interface to_rs1
mpls add interface to_rs5
mpls start
! Configure RSVP
rsvp add interface to_rs1
rsvp add interface to_rs5
rsvp start