CIRCUTOR PowerStudio Series - Manual (Page 110)

PowerStudio PowerStudio
110 User Manual
1.31.- CVM-K
1.31.1 Connection with modbus TCP
The CVM-K devices can connect on MODBUSTCP connections with some limitations.
PowerStudio can read the values measured by the device but cannot read the configuration. Although
it is not possible to read the configuration, for the correct value display, PowerStudio needs to know
certain information about the device. This information should be entered by the user, and it will be the
responsibility of the user to ensure that the data corresponds to the device connected. If this data
introduced by the user were incorrect it could give communication errors making it impossible for
PowerStudio to show the values measured by the device.
When adding a device on a MODBUSTCP connection, see section 1.20 TCP2RS ModbusTCP
converter. PowerStudio displays the following warning:
Then a dialogue box will appear with the information PowerStudio needs to communicate with the
device.
The user must select the correct information corresponding to the device connected.