CIRCUTOR PowerStudio Series - Manual (Page 241)

PowerStudio
User Manual 241
-
IP address: Corresponds to the IP address used to communicate with the device.
-
Subnet mask: Corresponds to the subnet mask used on the network where the device is
connected
- Predetermined Gateway: Corresponds to the address of the gateway if the device is not on
the same network as the PC containing the program.
- Obtain an IP address automatically (DHCP): This option will be enabled when we want the
device to automatically receive the IP address via a DHCP server.
- Port: Corresponds to the device communications port.
• Advanced configuration: Allows you to configure of a series of additional parameters on the
device. Refer to ‘Editor manual’.
On adding or modifying the device, the software will try to detect it. If it is unable to detect it, the device
is new and no IP has been assigned or a different IP to that entered in the ‘Converter Address’ has
been assigned, it will ask if you wish to assign a new IP address to the converter.
An IP address can only be assigned to the device if it is on the same network as the
computer running the program.
If the answer is ‘Yes’, the following dialogue box will appear, which will permit an IP address to
be assigned to the device.