CIRCUTOR PowerStudio Series - Manual (Page 139)

PowerStudio
User Manual 139
This selector configures the type of distortion calculated by the device.
Clicking the button will reset the energy meters on the device to zero.
This section shows the configuration of the two relay outputs of the device , which may be
configured with the desired values.
• Variable: The parameters associated with the relay are indicated in this field. The output is
programmed as an alarm or energy pulse and any of the parameters measured by the device
can be controlled. The maximum and minimum alarm unit values are indicated in brackets.
• Max: This checkbox shows the maximum value that must be controlled. If an energy variable
is selected, the value of each pulse will be indicated. It will be displayed as follows:
• Min: This checkbox shows the minimum value that must be controlled. If you select an energy
variable, this field will remain disabled.
• Delay: Alarm delay in seconds. The maximum value is 9999 seconds. This field will be
disabled if an energy variable has been selected.