CIRCUTOR PowerStudio Series - Manual (Page 228)

PowerStudio PowerStudio
228 User Manual
1.58.2.1.2 RGU-10 RA
The RGU-10 RA device will show the following value screen:
Where:
1. Protection status:
♦
Not tripped
♦
Tripped.
2. Additional information on the protection status.
3. Information that appears only when the reconnection is enabled
4. Differential current value detected in the channel trigger. This information will
be visible only when the channel is tripped.
5. Reconnection status or channel locking indicator
♦
Normal
♦  . Blinking. The device is timing the reconnection
♦
. Fixed. The channel is locked.
6. Additional information on the interlocking status.
7. Table with the partial and total counter values.
8. Cut-off Element configured.
9. Information about the configured trigger current threshold
10. Information about the configured trigger time.
11. Adjustment button. Displays channel information and allows some parameters
to be modified.
12. Reset button. If the channel is not triggered, the button will remain disabled.
Push the button to restart the channel.
13. Off button. Enables remote triggering of the channel to be made. If the
channel is tripped the button will remain disabled.
14. Instantaneous differential current value. If the value exceeds the limits of the
values bar, both over or under, an arrow below the value will indicate this).
15. Trigger threshold value configured for the channel