CIRCUTOR PowerStudio Series - Manual (Page 19)

PowerStudio
User Manual 19
1.4.- IP Camera
The IP Camera device only allows a captured image to be displayed, either by connecting
directly with a camera with an Ethernet connection, a video recorder to which petitions can
be made or webcams.
It will not be possible to record, display recordings or carry out any other action on the
image displayed, such as motion detection, from the sources described above.
The IP Camera device can display images generated from different sources (IP cameras,
videos, webcams, etc.), provided web requests can be made to these sources and the response is a
still image in JPEG format or video streaming MJPEG format.
1.4.1 Adding an IP Camera
For more information on how to add a device refer to 'Editor Manual'. The following parameters
are used to configure communication with an IP camera device.
• Name: Alphanumeric field that uniquely identifies the device throughout the program.
There are no two devices in the configuration with the same name.
• Description: Enter a brief description of the device using alphanumeric type data.
• IP Address: Corresponds to the address through which the program can
communicate with the device. This parameter can be an IP address or a name.
• Port: Corresponds to the communications port.
• Type: Type of image returned by the device. Video may be displayed in either MJPEG
format or still picture
• Refresh each image: Only used for fixed images; dictates how often in seconds the
program should request a new image.
• Route/Request: Corresponds to the request that must be made to the device to
obtain the video or image requested.