Displaying snmp statistics – ATL Telecom R1-SW Ethernet Switch User Manual
Page 150
R1-SW24L2B User’s Manual
8-16
Displaying SNMP Statistics
To display SNMP statistics, use the show snmp-server statistics command in
Privileged mode.
The following is sample output from the show snmp-server statistics command:
# show snmp-server statistics
10090
SNMP packets input
0
Bad SNMP version errors
96
Unknown community name
0
Illegal operation for community name supplied
0
Encoding errors
28051
Number of requested variables
12
Number of altered variables
9854
Get-request PDUs
83
Get-next PDUs
12
Set-request PDUs
9994
SNMP packet output
0
Too big errors (Maximum packet size 1500)
3
No such name errors
0
Bad values errors
0
General errors
9994
Response PDUs
0
Trap PDUs
#
The table below describes the fields shown by the show snmp-server statistics
command output:
Table 8-11 show snmp-server statistics field descriptions
Field
Description
SNMP packets input
Total number of SNMP packets input.
Bad SNMP version errors
Number of packets with an invalid SNMP version.
Unknown community name
Number of SNMP packets with an unknown community name.
Illegal operation for
community name supplied
Number of packets requesting an operation not allowed for that
community.
Encoding errors
Number of SNMP packets that were improperly encoded.
Number of requested
variables
Number of variables requested by SNMP managers.