ATL Telecom R1-SW Ethernet Switch - Manual (Page 38)

R1-SW24L2B User’s Manual
2-10
Both the RJ-45 connector and the LC connector (SFP module) cannot be used as Gigabit Ethernet
port at the same time. For example, if a RJ-45 connector of 10/100/1000Base-T port is connected
to a Gigabit Ethernet device, a LC connector of SFP port is automatically disabled.
The following table lists the specifications of the Gigabit Ethernet port on the OPT-N1EL1CD
module:
Table 2-11 Specifications of Gigabit Ethernet Port on the OPT-N1EL1CD Module
Feature 10/100/1000Base-T Port 100/1000Base-SX/LX SFP Port
Transfer Mode
Full-duplex mode or Half-duplex
mode (Auto sensing)
Full-duplex mode
Transfer Speed 10/100/1000Mbps 100/1000Mbps
Connector Type RJ-45 Duplex LC
Maximum
Transfer Distance
100m
y 100/ 1000Base-SX : 550m
y 100/ 1000Base-LX : 10Km
Transfer Media Twisted-pair category-5+, 6 cable
y 100/ 1000Base-SX : 850nm Multi-mode
y 100/ 1000Base-LX : 1310nm Single mode
Gigabit Ethernet Port LED (B)
The following table describes the information indicated by LEDs of the Gigabit Ethernet port on
the OPT-N1EL1CD module:
Table 2-12 LED Functions of Gigabit Ethernet Port on the OPT-N1EL1CD Module
LED Color State Description
On Indicates that the port have established a valid link with the network.
Blink Indicates that the port is transmitting or receiving data.
ACT/
LINK
(A, B)
Green
Off
Indicates that the port have not established a valid link with the
network.
On Indicates that the port is operating at 1000Mbps speed. SPEED
1000
Orange
Off Indicates that the port is operating at 100Mbps speed.