ATL Telecom R1-SW Ethernet Switch - Manual (Page 83)

Basic Configuration
5-15
Changing a User Password
To change a user password for a user, follow this procedure:
Table 5-7 Changing a user password
Command Task
configure terminal 1. Enter Global configuration mode..
username <name> passwd
<password> [8]
2. Specify a new password.
y <name>: The user name to modify password.
y <password>: New password
y 8: Encrypts the password.
end 3. Return to Privileged mode.
write memory 4. Save the configuration change.
The following is an example of changing a password of the user ‘
kka ’:
# configure terminal
(config)# username kka password R1SW24L2B
(config)# end
# write memory
Building Configuration...
[OK]
#
Deleting a User
To delete a user, follow this procedure:
Table 5-8 Deleting a user
Command Task
configure terminal 1. Enter Global configuration mode.
no username <name>
2. Delete a user.
y <user-name>: The user name to delete.
end 3. Return to Privileged mode.
show username 4. Verify the list of users.
write memory 5. Save the configuration change.