Stp configuration commands – ATL Telecom R1-SW Ethernet Switch User Manual
Page 287
Configuring STP/RSTP
13-29
STP Configuration Commands
The following table lists the commands for configuring STP on the Corecess R1-SW24L2B:
Table 13-16 STP configuration commands
Command
Description
port pathcost
Sets the spanning-tree port path cost for the specified Ethernet port.
port priority
Sets the spanning-tree port priority for the specified Ethernet port.
port stp
Enables or disables STP(Spanning Tree Protocol) on the specified
Ethernet port.
show stp port
Displays spanning-tree information for the specified port.
show stp vlan
Displays spanning-tree information for the specified VLAN interface.
stp adminEdge port
Configures a port as an Edge port.
stp bridge-priority
Sets the bridge ID for a VLAN.
stp forward-delay
Sets the bridge forward delay for a VLAN.
stp hello-time
Sets the bridge hello time for a VLAN.
stp max-age
Sets the bridge maximum aging time for a VLAN.
stp pathcost-encoding
Configures the type of Spanning Tree Protocol encoding mode.
stp protocol-version
Configure the type of Spanning Tree Protocol mode to run for a specific
VLAN.
stp vlan
Enables the spanning tree algorithm for a specific VLAN.