Kurzweil Forte - Manual (Page 166)

Program Edit Mode
Arpeggiator Step Sequencer Mode Parameters
7-69
Arpeggiator Step Sequencer Mode Parameters
In Step Sequencer mode, the ARP page will give you the ability to create a unique
Arpeggiator pattern step-by-step.
Select a parameter using the up/down navigation buttons. To change steps, select the Step#
parameter, then press the left or right navigation buttons.
Parameter Range of Values Default
Number Steps 1-48 3
Step# 1-48 1
Note -128 to +127 0
Veloc (Velocity) -128 to +127 0
Durat (Duration) 0-100 100
Beats 1/1 to 1/96 1/16
Use the Number Steps parameter to set the number of steps in the current sequence.
The Step# parameter shows the number of each step in the sequence, and can be used to
navigate between the steps.
The Step Sequencer specifies four parameters for each step: Note, Veloc (Velocity), Durat
(Duration) and Beats. Use the navigation buttons to move between pattern steps, use the
Alpha Wheel, alphanumeric pad, or plus/minus buttons to enter the parameter values for
each step.
Note
values create the shift pattern for the Step sequence. Notes are specified in half-steps
from the last latched note (represented as 0). Thus, this series of notes: 0, 4, 7 will play a triad
in sequence. Note values can range from -128 to +127, with negative numbers shifting below
the latched note.