Kurzweil Forte - Manual (Page 38)

Getting Started
2-11
Connecting to Your Audio System
After you’ve turned down the level on your sound system, connect the Forte analog audio
outputs to your sound system using a pair of balanced (TRS or “stereo”) or unbalanced (TS or
“mono”) audio cables. Unbalanced cables will always work, but if you’re going into balanced
inputs, use balanced cables for a better signal-to-noise ratio and a bit more volume. The Forte
analog outputs are balanced.
You’ll find four 1/4-inch balanced audio output jacks on the rear panel, the “A” Audio Output
pair and the “B” Output pair. Connect one end of each audio cable to the “A” Audio Output
jacks found on the rear panel of the Forte marked “Left (Mono)” and“Right,” and the other end
to your mixing console or PA system inputs. If you have only one input available, use the Forte’s
Left (Mono) output to get the full signal in mono. Use the jack marked Headphones (located
on the front/left of the instrument) to listen to Forte on headphones. When headphones are
plugged in, sound still comes through the Left and Right audio jacks.
Forte connected to powered speakers and headphones
“A” AUDIO OUTPUTS
NOTE: Headphone jack on the
Forte7 is on the rear panel