Kurzweil Forte - Manual (Page 262)

Multi Edit Mode
MAIN Page
11-11
Output
Use the Out parameter to set the rear panel audio outputs used for each zone of the current
Multi. This parameter determines the output settings for the main program signal and insert
effects of each zone
A setting of Auto will make that zone output audio based on the settings for the program
used by that zone. Program output settings are set in the Program Editor using the Output
parameter on the FX page.
A setting of A will output Zone audio to the “A” Balanced Analog Outputs.
A setting of B will output Zone audio to the “B” Balanced Analog Outputs.
Channel
The Channel parameter determines the MIDI transmit and receive channel for the currently
selected Zone. You can set this parameter to any of the 16 MIDI channels (1-16).
You can assign different Zones to the same channel, but only one Program can be loaded in a
channel at a particular time. The Program loaded will be whichever program change message
is received last.
Bank Mode
The Bank Mode parameter determines the controller number with which MIDI Bank change
messages are transmitted. For MIDI Bank change messages, various manufacturers have
chosen different MIDI controller numbers. Most have chosen 0, 32, or both. In the case of
the Kurzweil K2600, it responds to controller 32, but is limited to 100 programs per bank.
You can set this parameter to any of the following:
None MIDI Bank change messages are disabled.
Ctl0 MIDI Bank change messages are sent with controller number 0.
Ctl32 MIDI Bank change messages are sent with controller number 32.
Ctl0/32 MIDI Bank change messages are sent with both controller numbers 0 and 32.
K2600
MIDI Bank change messages are sent with controller number 32. ( K2600 Program
numbers 0-99.)