Kurzweil Forte - Manual (Page 315)

Global Mode
AUDIO_IN (Audio Input)
12-25
FX
Set the FX parameter to Yes or No to enable or disable audio input effects.
FX Chain
When the Audio Input FX parameter is set to Yes, you can use the FX Chain parameter to
select an FX chain to apply to the rear panel 1/8” (3.5 mm) input signal. If you wish to edit a
Chain, you can enter the Chain Editor by pressing the Favorites 1 button (see Ch. 8 The
Effects Chain Editor for details).
When selecting an Audio Input Chain, the Chain may steal FX unit resources from other
channels in order to load if more resources are needed to load the Chain. When stealing
occurs, resources in higher numbered channels will be stolen first, and in Program Mode
resources in the currently selected channel will be stolen last.
Control
When the “Control” parameter is set to “No Real Time Control”, the Effects Chain Mods
are disabled. Set the “Control” parameter to “Current Channel Control” to enable the Effects
Chain Mods of the selected Chain.
In Program Mode, Mods assigned within the selected Audio Input Chain can be controlled
by the Forte’s physical controllers. See the About Effects Chain Mods section below for more
details.
In Multi Mode, if a Multi is selected which has its Audio Input Mode set to “Use Global
Mode Effects”, any Mods assigned within the selected Audio Input Chain can be controlled
by controllers assigned in a Zone set to the same MIDI channel as the current setting for the
Multi’s “AuxFX Ch” parameter. See the About Effects Chain Mods section below for more
details.
About Effects Chain Mods
Effects Chain Mods are modulation controls which can be assigned to the Forte’s physical
controllers. For example, an Effects Chain Mod assigned to a slider can be used to adjust the
dry/wet effect mix, or control other parameters like reverb or delay time.
When the “Control” parameter is set to “Current Channel Control”, Mods assigned within
the selected Audio Input Chain can be controlled by controllers sending the same CC
numbers from the currently selected Program or Multi.
To view the Mods of the selected Audio Input Chain, select the FX Chain field and press the
Favorites 1 button to enter the Chain Editor, then go to the Chain Info page (see Ch. 8
The Effects Chain Editor for details).