Kurzweil Forte - Manual (Page 255)

Multi Edit Mode
Selecting Parameters
11-4
Changing Zones
Use the Channel/Zone Up and Down buttons to change the currently selected Zone.
The top right corner of the display of the MAIN & CONTROLS pages shows the currently
selected Zone out of the total number of Zones, or “All Zones” if the parameter applies to all
Zones.
On the Multi Edit Overview page the Channel/Zone Up/Down buttons will change Zones
in reverse order from how they do on other Multi Edit pages. Pressing Zone Down will select
a higher Zone and pressing Zone Up will select a lower Zone. The buttons are reversed on
this page so that pressing Zone Up/Down will move you visually up/down on the display. A
simultaneous double button press of Zone Up/Down will jump to Zone 1.
Alpha Wheel & Previous (–) and Next (+) Value Buttons
Use the Alpha Wheel or the Value buttons, to the right of the display below the Alpha
Wheel, to change the selected parameter value. Turning the Alpha Wheel counter-clockwise
or pressing the Previous button will select the previous value and turning the Alpha Wheel
clockwise or pressing the Next button will select the next value.
Assign
Assign is the secondary function of the Enter button. You can use the Assign function to
quickly select parameters or set values for parameters by holding the Enter button while
moving Forte controllers (Sliders, Switch buttons, Keys, Mod Wheel, and Pedals).