Audio input mods in program mode, Audio input mods in multi mode – Kurzweil Forte User Manual
Page 316
Global Mode
AUDIO_IN (Audio Input)
12-26
Audio Input Mods in Program Mode
To control Audio Input Mods in Program Mode, first make sure the Global “Control”
parameter is set to “Current Channel Control”. In Program Mode, the Forte’s physical
controllers send the MIDI CC numbers listed in the table below. If the selected Chain
contains Mods which use any of these MIDI CC numbers, effects parameters will be
controllable by using the physical controllers which have corresponding MIDI numbers.
Use the Chain editor if you wish to add Mods, remove Mods, or change their MIDI
assignments. Select the Chain field and press the Favorites 1 button to enter the Chain
Editor. See
for details on editing Chain Mods.
Forte Controller MIDI CCs
Mod Wheel (MIDI 1)
Slider G (MIDI 26)
Zone 1 Switch (MIDI 80)
CC Pedal 1 (MIDI 11)
Slider H (MIDI 27)
Zone 2 Switch (MIDI 81)
CC Pedal 2 (MIDI 4)
Slider I (MIDI 28)
Zone 3 Switch (MIDI 82)
Slider A (MIDI 12)
Variation Switch (MIDI 29)
Zone 4 Switch (MIDI 83)
Slider B (MIDI 13)
Sw.Pedal 1 (MIDI 64)
Assignable Switch 1 (MIDI 85)
Slider C (MIDI 22)
Sw.Pedal 2 (MIDI 66)
Assignable Switch 2 (MIDI 86)
Slider D (MIDI 23)
Sw.Pedal 3 (MIDI 66)
Assignable Switch 3 (MIDI 87)
Slider E (MIDI 24)
Assignable Switch 4 (MIDI 89)
Slider F (MIDI 25)
Assignable Switch 5 (MIDI 90)
Audio Input Mods in Multi Mode
To control Audio Input Mods in Multi Mode, first make sure the Global “Control”
parameter is set to “Current Channel Control”. On the Multi Edit Controls page, use the
Destination field to assign a Multi controller to send the desired FX Mod CC number (see
for details). The Zone used to send these CC numbers
must have a MIDI Channel which matches the current setting for the Multi’s “AuxFX Ch”
parameter. See
for details.