Kurzweil Forte - Manual (Page 256)

Multi Edit Mode
Selecting Parameters
11-5
Parameters that can use the Assign function are indicated by showing the Assign symbol in
the top right corner of the display when selected.
Assign Symbol
Pressing a key, switch, or moving a controller while holding down the Enter button will
perform Assign in the following cases.
Enter + Controller
In Multi Edit Mode on the Controls page, when the Controller parameter is selected,
holding the Enter button and moving a controller (a Slider, Switch button, Mod Wheel or
Pedal) will jump to selecting that controller in the current Zone. This allows you to quickly
select a controller.
In a Controller destination field in Multi Edit Mode, Enter + Controller will assign the
Destination of the touched controller to the selected controller.
Using Enter + Controller in an OnValue or OffValue field or in an Entry Position or Exit
Value field, will set the value of that controller to the field value. For example if you want to
set an OnValue to a value of 100, you can hold Enter and move a controller to quickly set
OnValue to 100.
Enter + Key
In Multi Edit Mode, on the Overview page, with the Low Key Range or High Key Range
parameter selected, hold the Enter button and strike a key to set the Low Key or High Key.
This will also work on the Control page with a Switch selected, when Mode = Chord. The
value of the Key fields can be set using Enter + Key.