Canon EOS RP Mirrorless Camera - Manual (Page 487)

487
Sending Images to a Web Service
o With a Wi-Fi connection to a Web service established, a picture cannot be
taken even if the camera’s shutter button is pressed.
o When sending an image to a Web service other than CANON iMAGE
GATEWAY, a send error message may not be displayed even if the image has
not been sent to the Web service successfully. Since such send errors can be
checked on the CANON iMAGE GATEWAY site, check the error content, then
try sending the image again.
o Depending on the Web service, the type or number of images that can be sent
and the length of movies will be limited.
o Certain images may not be able to be sent with [Send range] , [Send all
card] , or [Send all found] .
o When you reduce the image size, all images to be sent at the same time are
resized. Note that movies or
b
size still photos are not reduced.
o [Reduced] is enabled only for still photos shot with cameras of the same
model as this camera. Still photos shot with other models are sent without
resizing.
o When accessing CANON iMAGE GATEWAY from a computer or other device,
you can check the send history for the Web services that the images were
sent to.
o To terminate the Wi-Fi connection without sending an image, press the
<
M
> button on the screen for step 1.
o When you use a battery to power the camera, make sure it is fully charged.