Charging a battery in the camera – Canon EOS RP Mirrorless Camera User Manual
Page 558
558
Charging a Battery in the Camera
Using USB Power Adapter PD-E1 (sold separately), you can charge Battery
Pack LP-E17 without removing it from the camera.
Charging stops if you
operate the camera.
1
Connect the USB power adapter.
z
With the camera’s power switch set to
<
2
>, insert the USB power adapter
plug fully into the digital terminal.
2
Connect the power cord.
z
Connect the power cord to the USB
power adapter and plug the other end
into a power outlet.
g
Charging begins, and the access lamp
(1) is lit in green.
(1)
z
When charging is finished, the access
lamp turns off. Unplug the power cord
and disconnect the USB power adapter
from the camera.
o
To protect batteries and keep them in optimal condition, do not charge
continuously for more than 24 hours.
o
In case of charging problems, the access lamp blinks in green and a protective
circuit stops charging. In this case, unplug the power cord, reattach the battery,
and wait a few minutes before plugging it in again. If the problem persists,
contact your dealer or nearest Canon Service Center.