Canon EOS RP Mirrorless Camera - Manual (Page 501)

501
Responding to Error Messages
11: Connection target not found
z
In the case of [
q
] , is Camera Connect running?
g
Establish a connection using Camera Connect ( = 435).
z
In the case of [
l
] , is the power of the printer on?
g
Turn on the printer.
z
In the case of [
D
] , is the EOS software running?
g
Start the EOS software and reestablish the connection ( = 455).
z
Are the camera and the access point set to use the same password for
authentication?
g
This error occurs if the passwords do not match when the
authentication method for encryption is set to [Open system] .
The setting is case-sensitive, so check upper- and lower-case
characters. Make sure that the correct password for authentication is
set on the camera ( = 517).
12: Connection target not found
z
Is the power of the target device and access point on?
g
Turn on the target device and access point, then wait a while. If a
connection still cannot be established, perform the procedures to
establish the connection again.