Canon EOS RP Mirrorless Camera User Manual
Page 563
563
Troubleshooting
Batteries cannot be charged with the USB power adapter (sold
separately).
z
Batteries are not charged while the camera’s power switch is set to
<
1
>.
z
Operating the camera will stop charging in progress.
The access lamp blinks during charging with the USB power
adapter.
z
In case of charging problems, the access lamp blinks in green and a
protective circuit stops charging. In this case, unplug the power cord,
reattach the battery, and wait a few minutes before plugging it in again.
If the problem persists, contact your dealer or nearest Canon Service
Center.
The access lamp is not lit during charging with the USB power
adapter.
z
Try unplugging the USB power adapter and plugging it in again.
The camera is not activated even when the power switch is set
to <
1
>.
z
Make sure the card slot/battery compartment cover is closed (
z
Make sure the battery is installed properly in the camera (
z
Charge the battery (
The access lamp still lights or blinks even when the power
switch is set to <
2
>.
z
If the power is turned off while an image is being recorded to the card, the
access lamp will remain on or continue to blink for a few seconds. When
the image recording is complete, the power will turn off automatically.