ZyXEL Communications IP PBX X6004 - Manual (Page 180)

Chapter 7 Auto Provision
X6004 User’s Guide
180
7.3.5 snom Firmware Upgrade
Use this screen to configure the firmware upgrade URLs for the snom VoIP devices
connected to the X6004. To access this screen, click Configuration > PBX >
Server Configuration > Auto Provision > snom Profile Setup then click the
snom Firmware Upgrade button.
Figure 73 snom Profile Setting > snom Firmware Upgrade
Each field is described in the following table.
Table 39 snom Firmware Upgrade
LABEL DESCRIPTION
snom Firmware
Upgrade
Product List
This list corresponds to the snom products supported by the X6004.
URL Enter the upgrade URL for the device in question. You can find this URL
and any other upgrade information at the product page on the official
snom website.
Set Firmware
Url Click Set Firmware URL to save the URL(s) entered on this page.
Cancel Click Cancel to go back to the snom Profile Setup screen without
saving any changes.