ZyXEL Communications IP PBX X6004 - Manual (Page 351)

Chapter 22 Call Services
X6004 User’s Guide
351
22.5 The Distinctive Ring Screen
The X6004 allows you to select different ring tones based on the origins of calls
routed through the X6004.
Click Configuration > PBX > Call Services > Distinctive Ring to configure the
distinctive ring feature.
Note: This function works only when the callee uses an analog phone connected to
X6004’s FXS port, a ZyXEL softphone such as V100 or a ZyXEL IP phone such
as V500.
Figure 199 Distinctive Ring
The following table describes the labels in this screen.
Table 122 Distinctive Ring
LABEL DESCRIPTION
Active Select this to activate the distinctive ring feature.
Ring Tone Select a ring tone (1~12) and press Playback to listen to the ring tone
on the computer that you are using to configure the X6004.
Internal Call Select the ring tone for internal calls (calls from one X6004’s extension to
another X6004’s extension).
SIP Trunk Select the ring tone for calls coming in from the SIP trunk (for example
your connection to the ITSP).
FXO Select the ring tone for calls coming in from the FXO trunk (for example
your connection to the PSTN).
PRI Select the ring tone for calls coming in from the PRI trunk (for example
your connection to an ISDN T1/E1 line).
BRI Select the ring tone for calls coming in from the BRI trunk (for example
your connection to an ISDN BRI line).
Apply Click this to save your changes.
Reset Click this to set every field in this screen to its last-saved value.