ZyXEL Communications IP PBX X6004 - Manual (Page 287)

Chapter 18 Outbound Line Group
X6004 User’s Guide
287
Each field is described in the following table.
18.4 Add/Edit BRI Trunk
The screens for editing or adding BRI trunks on the X6004 contain the same fields.
Only the screen used to add BRI trunks is shown below. Click the Add (or Edit)
icon in the BRI Trunk section of the Outbound Line Group configuration screen
to view the screen as shown.
Figure 150 Add/Edit BRI Trunk
Each field is described in the following table.
Table 92 AA for Incoming PRI Calls
LABEL DESCRIPTION
Apply AA Select an Auto-Attendant or ACD skill profile used for the calls incoming
through this PRI trunk.
Apply Click this to save your changes and to apply them to the X6004.
Cancel Click this to go to the Outbound Group screen without saving your
changes.
Table 93 Add/Edit BRI Trunk
LABEL DESCRIPTION
Machine ID Select the ID of the X6004 on which you want to configure the BRI
interface. This is an internal name (not configurable) of the X6004. Only
one choice is shown if you have not configured ZyStack.
This field is not available when editing an BRI configuration.
Group Name Type the name of this BRI interface. This field can be 1-20
alphanumeric characters (A-Z, a-z, 0-9) and underscores (_).
Description Type the description for this BRI interface. This field can be 0-63
alphanumeric characters (A-Z, a-z, 0-9), underscores (_), hyphens (-)
and spaces. 0 means this field can be left blank.
Apply Click Apply to save your changes.
Back to
Outbound
Group/Cancel Click this to go to the Outbound Line Group screen without saving
your changes.