ZyXEL Communications IP PBX X6004 - Manual (Page 354)

Chapter 22 Call Services
X6004 User’s Guide
354
22.7.1 Configuring the Call Parking Screen
Use this screen to configure call parking on the X6004. Click Configuration >
PBX > Call Services > Call Park to open the screen.
Figure 202 Call Parking Configuration
The following table describes the labels in this screen.
6. Caller B walks to another
extension and reconnects
to the call with A by
dialing # followed by the
parking slot number.
Conversation between caller A and B continues
Table 124 Call Parking Progression
CALLER A X6004 CALLER B
Table 125 Call Parking Configuration
LABEL DESCRIPTION
Call Parking
Setting
Representativ
e Number
Enter the telephone number users should dial to park a telephone call.
You can use 3-10 digits.
Amount of
Parking
Position /
ZyStack Enter the number of call parking extensions available. This also
establishes the range of numbers that users will have to dial to retrieve a
parked call. You can use 1-99 positions.
Parking Time Enter the maximum number of seconds that a call can be parked. After a
parked call exceeds this amount of time, it will hang up. The range you
can use is 60-300 seconds.
Apply Click this to save your changes and to apply them to the X6004.
Reset Click this to set every field in this screen to its last-saved value.