2 auto-attendant for incoming pri calls, Figure 149 aa for incoming pri calls – ZyXEL Communications IP PBX X6004 User Manual
Page 286
Chapter 18 Outbound Line Group
X6004 User’s Guide
286
18.3.2 Auto-Attendant for Incoming PRI Calls
Use this screen to select which auto-attendant should be used with this outbound
line group. See
for information on configuring auto-
attendant. Click the Auto-Attendant icon in the in the PRI Trunk section of the
Outbound Group configuration screen to view the screen as shown.
Figure 149 AA for Incoming PRI Calls
Type of Number Select the type for the prefix number which might be required by your
telephone company to make outgoing calls. The options you can select
are UNKNOWN, INTERNATIONAL, NATIONAL, NETWORK,
SUBSCRIBER, ABBREVIATED.
Calling Party
Number Prefix
Enter a number to add in the beginning of the outgoing caller’s numbers
using this trunk line. This field can be 0-20 digits in length.
Calling Party
Number
The settings in this section are optional. Leave them empty to allow all
incoming calls. Alternatively, you can define trusted caller number(s) to
filter incoming callers. Then the X6004 only forwards the calls that their
caller numbers are listed in the trusted caller table.
Length
Enter a number (1~10) to identify the phone number length for trusted
callers.
Trusted Peer
Enter a phone number you accept the caller to dial extensions using this
outbound group. Click the Add icon to add a number into the trusted
caller table. Click the Delete icon to remove a number.
This field can be 1-10 digits or 1-10 digits - 1-10 digits (two sets of up
to ten digits separated by a hyphen). For example, 5783900 or
5783900-5783999.
Incoming
Calling Party
Number
Use this section to configure your incoming calling party numbers.
Type of Number This indicates the type of incoming call to which you can associate a
dialing prefix.
Prefix
Assign a custom prefix to appended to this type of incoming call.
Apply
Click this to save your changes.
Cancel
Click this to go to the Outbound Line Group screen without saving
your changes.
Table 91 Configure a PRI Trunk (continued)
LABEL
DESCRIPTION