ZyXEL Communications IP PBX X6004 - Manual (Page 461)

Chapter 33 Remote Management
X6004 User’s Guide
461
The following table describes the labels in this screen.
33.10 The CTI Screen
You can use a ZyXEL V200 SIP phone to access and download the X6004’s
phonebook information through port 5038.
To view or change your X6004’s CTI settings, click Maintenance >
Administration > Remote Management > CTI. The screen appears as shown.
Use this screen to specify which interfaces allow CTI access and from which IP
address the access can come.
Figure 267 Remote Management > CTI
Table 183 ICMP > Add/Edit
LABEL DESCRIPTION
Access
Interface Select the interface(s) through which computer(s) may ping the X6004
using this service. Select ALL to have the X6004 respond ping packets
sent from the specified computer(s) X6004 through either LAN or WAN
interface.
Address Type Select ALL to have the X6004 respond ping packets from any
computers.
Select Host and specify the IP address of a trusted computer to have
the X6004 respond ping packets from the computer.
Select Subnet and specify the IP addresses of a trusted subnet to have
the X6004 respond ping packets from all computers from the subnet
network.
Apply Click this to save your changes and to apply them to the X6004.
Cancel Click this to begin configuring the fields again.