ZyXEL Communications IP PBX X6004 - Manual (Page 357)

Chapter 22 Call Services
X6004 User’s Guide
357
22.8.1 Configuring the Call Waiting Screen
Use this screen to configure call waiting on the X6004. Click Configuration >
PBX > Call Services > Call Waiting to open the screen as following.
Figure 205 Call Waiting Setting
The following table describes the labels in this screen.
Table 128 Call Waiting Setting
LABEL DESCRIPTION
Call Waiting Select Enable or Disable to turn this feature on or off.
If you enable this feature, then call waiting will apply to all extensions
except the disable list below and ISDN extesions.
If you disable this feature, then call waiting will only apply to the
extensions in the enable list below.
Disable/
Enable List To add one extension, select an available one in the Extension List field,
click the Right button (to add it into the Setting List field). You can
remove extensions from the list by selecting one extension in the Setting
List field and click the Left button.
Apply Click this to save your changes and to apply them to the X6004.
Reset Click this to set every field in this screen to its last-saved value.