West Control Solutions KS98-1 - Manual (Page 108)

III-4.4 BOUNCE (debouncer (No. 63))
This function is used for de-bouncing a logic signal. The change of input signal d1 is transferred to output z1 only,
when it remained constant for the time adjusted in parameter Delay. The time-out accuracy is dependent of the sam -
pling interval assigned to the function.
Example:
–
Delay = 0,5s for assignment to
- sampling interval 100ms means that the signal is transferred only after ? 0,5s.
- Sampling interval 200ms means that the signal is transferred only after ? 0,6s.
- Sampling interval 400ms means that the signal is transferred only after ? 0,8s.
- Sampling interval 800ms means that the signal is transferred only after ? 0,8s.
Parameter Description Range Default
Delay Switch-on and off delay time 0...999 999 [s] 0
III-4.5 EXOR (exclusive OR gate (No. 64))
z d EXOR d
1 1 2
=
Logic inputs d1 and d2 are combined into z1 according to the truth table given below. Unused inputs are inter-
preted as logic 0.
Output z1 is 0, when the two inputs are equal (both 0 or both 1).
d1 d2 z1 not z1
0 0 0 1
0 1 1 0
1 0 1 0
1 1 0 1
9499-040-82711 Logic functions
BOUNCE (debouncer (No. 63)) III-108
d1
z1
Delay
Delay Delay
d1
d2
=1
z1
not z1