West Control Solutions KS98-1 - Manual (Page 79)

x For this purpose, we return to the
soft-wiring mode ( hand pointer ) and
click with the right mouse key on the
function block for which we are setting
the parameters. The individual parame-
ter dialogue of the selected function
block appears.
c Now the parameter is selected with a
click into the text field. Its signification
is displayed in concise form in the bot-
tom field of the input mask.
When opening the input field by clicking
twice, a listbox for selection is offered.
v When leaving the parameter dialogue
with OK, the block setting is completed.
The engineering for a simple control loop is also completed. Only the function test has still to be passed. For this, eit -
her a KS 98-1 or the simulation are required.
The instrument settings are dependent on whether a simulator or a real instrument are used for testing:
Test with device
In the ETKS98 atr device-device selection the adjustment to the existing device is made.
Therefore the product-code-no. of the device (sideways on the typeplate) is written into the "order-number" field
With OK the adjustment is confirmed.
For communication with the device a serial connection
(COMport from the PC) with the device via pc-adapter is
set up.
Check r Menu - Options - Communication in the
ETKS98, if the interface is set to Com 1.
Test with the Simulation
Start SIM-KS98-1. Select the version to be simulated
atr Menu -Settings-Device.
In the ETKS98 atr device-device selection fill in
the product-code-no of the simulation (written in the field
order-no of the simulation). Confirmed with OK.
For communication with the simulation, in the engineering-tool the interface is set to SIM/KS98-1 via the Menu Op-
tions-Communication.
After all this preparations we can load our little test-project, via Menu File-Project->KS98-1-Engineering. All con-
trol requests we confirm with OK.
9499-040-82711 Building an engineering
II-79
Fig. 103
<<Klick
Fig. 104