West Control Solutions KS98-1 - Manual (Page 207)

w 2 = reset + stop: Programmer goes to rest condition Wp0
At program end, the number of the last segment increased by 1 is output as active segment number ( SegNo output
of operating page and interface). This is required to bring the slave block to the end status safely with a segment pre -
set.
Start
The programmer uses a common start Wp0 for all programs. However, using an individual start for a recipe is possi -
ble as follows:
Use the of the 1st segment of each program as start value.
Set the relevant segment time (Tp1) to 0.
Set the search run parameter Smode to ’Search run in program sections‘. Now, the search run is not limited to the 1st
segment and program start at the process value in the 2nd segment is possible (see search run, page -> marking(SS)).
If each recipe shall have a separate reset (Wp0), function blocks REZEPT and VPARA can be used as shown up 40.
Note the calculation order (APROG r REZEPT r VPARA).
9499-040-82711 Programmer
APROG ( analog programmer (No. 24)) / APROGD ( APROG data (No. 25)) III-207
recipe 1
recipe 2
recipe 3
pshow
Fig. 40 Recipees with separate starting setpionts
Preparation
for
operation
operation
expired
program time
program
START
program
START
program
ENDE = RESET
operation
RESET
time
RESET
PRESET PRESET
Process
value x
Wp0
Process
value x
Preparation
for
operation
Fig. 41 Profile with automatic reset at program end