West Control Solutions KS98-1 - Manual (Page 53)

II-2.3 Licencing
During initial installation of the engineering tool,
an input mask (r Fig.:36 ) for entry of the licence number is dis-
played. Unless a licence number is entered, the engineering tool
starts only as a demonstration version with limited functions (sa-
ving and downloading of an engineering into KS 98-1 is not pos-
sible in the demonstration version). The licence number is given
on the enclosed registration form. Please, keep the registration
form carefully. You need the licence number in case of re-instal-
lation and when you have to make use of the technical support.
Please, complete the registration sheet immediately and send it
to the specified address via fax or as a copy via mail. In return,
you will get technical support and regular information on product
updates.
Please, note the PMA licence conditions for software products. Successful installations
are only possible onto a hard disk, but not on a network drive (only on request).
Updates
The licence number is stored in the system and need not be re-entered in case of an update.
Changing the licence number
A change of the licence number or licensing of a demonstration ver-
sion (conversion into a full version) can be done via the menu bar
(r Fig.:37 )“Lizenz”. In the window (r Fig.:38 ) displayed after cli-
cking on Licence, input mask ‘PMA licensing’ (r Fig.:36) can be
called up via Edit. Now, the new licence number can be entered in
this input mask.
II-2.4 Software start
Starting software “engineering tool KS 98-1" is by double-clicking on the icon created by the installation program in
program group ”PMA Tools".
9499-040-82711 Installation
Licencing II-53
Fig.: 36
Fig.: 37
Fig.: 38