West Control Solutions KS98-1 - Manual (Page 203)

Analog outputs (APROG):
Wp
Programmer
TNetto Net program time (] Trun)
TBrutt Gross program time (] Trun + ] Tstop)
TRest Programmer rest time
SegNo Actual segment number
WEnd End value of actual segment
ProgNo Actual program number (recipe)
SegRest Remaining segment time
Bl-no Own block-number (e.g. for coupling master and slave blocks)
Parameter
APROG Description Range Default
WMode Change mode:
Ramp Ramp t
Step Step
PMode Preset Mode:
Preset to segment Pres.time t
Preset to time Pres.seg.
TPrio Start mode in search run
Gradient has priority Grad.prio t
Segment/time has priority Time prio
Dp Decimals for setpoint 0..3 3
RecMax Max.recipees 1..99 99
Smode
Smode (search mode): 0 = search run in segment
1 = search run in program/section
2 = no search run
Wp0 Program at reset -29999 ... 999 999 0
W0 Untere Sollwertgrenze -29 999 ...999 999
-29 999
W100 Obere Sollwertgrenze -29 999 ...999 999
999 999
APROGD
Analog inputs (APROGD):
DBlock
Block number of cascaded data function `APROGD’
Analog outputs (APROGD):
DBlock
Own block number
Parameter
APROGD Description Range Default
ET Unit ET Unit
Tp 1 Time for segment 1 (Ü) 0 ... 59 999 0:00...999:59 OFF --:--
Wp 1 Segment end in segment 1 -29999 ... 999 999 0 0
Tp 2 Time for segment 2 (Ü) 0 ... 59 999 0:00...999:59 OFF --:--
Wp 2 Segment end in segment 2 -29999 ... 999 999 0 0
...
Tp 10
Time for segment 10 (Ü) 0 ... 59 999 0:00...999:59 OFF --:--
Wp 10 Segment end in segment 10 -29999 ... 999 999 0 0
Enter the time for a segment in seconds or minutes into the engineering tool dependent of configuration ( Turbo).
Entry into the unit is in Hrs:Min or Min:Sec. In addition to the range, a switch-off value can be entered (ET: OFF/-32000;
unit:
--:--). When reaching a segment with a switch-off value, ‘End‘ is output.
9499-040-82711 Programmer
APROG ( analog programmer (No. 24)) / APROGD ( APROG data (No. 25)) III-203