Rockwell Automation 20D PowerFlex 700H and 700S Frame 9...14 Drives - Manual (Page 110)

110 Rockwell Automation Publication PFLEX-IN006E-EN-P - July 2013
Chapter 8 Frame 12 Mechanical Installation
Figure 42 - Common Mode Jumper and Rectifier Circuit Board Location
DANGER DANGER DC BUS CONDUCTORS AND CAPACITORS OPERATE AT HIGH VOLTAGE. REMOVE POWER AND WAIT 5 MINUTES BEFORE SERVICING
DANGER DANGER DC BUS CONDUCTORS AND CAPACITORS OPERATE AT HIGH VOLTAGE. REMOVE POWER AND WAIT 5 MINUTES BEFORE SERVICING
Common Mode
jumper
Rectifier Circuit Board
Front View of
Assembly
There is one jumper located on each
Rectifying Module. The Rectifying Modules
are located on the upper-right side of the
right side power stack of in each enclosure
of the drive’s power structure.
Control Frame not shown for clarity only