Rockwell Automation 20D PowerFlex 700H and 700S Frame 9...14 Drives - Manual (Page 140)

140 Rockwell Automation Publication PFLEX-IN006E-EN-P - July 2013
Chapter 10 Frame 14 Mechanical Installation
Figure 59 - DC Input Drive Enclosure Code H (NEMA/UL Type 12, IP54) and W (NEMA/UL Type 12,
IP54 w/Conformal Coat)
Lifting and Mounting Frame
14 Drives Enclosed Frame 14 Drives with DC Input
Enclosed frame 14 drives with DC input are shipped with the control pan
mounted in the motor connection area of the left-hand enclosure. The control
pan must be moved from this location to a location in the adjacent enclosure,
away from the power connections.
See the Lifting and Mounting PowerFlex 700S and 700H Drives, Frames 10…14,
Installation Instructions, publication
PFLEX-IN005 , for detailed instructions.
These instructions are shipped with the drive. When you have completed the
instructions in PFLEX-IN005, continue with the installation as directed below.
675
(26.6)
125 (5.0) 62.25
(2.5)
475
(18.7)
65
(2.6)
30 (1.2)
68.75 (2.7)
799.5 (31.5)
675
(26.6)
2232
(88)
662
(26)
454
(18)
2276
(90)
1597 (63.0)
Lifting Points
799.5 (31.5) 799.5 (31.5)
CLOSE
OPEN
Dimensions are in millimeters and (inches).
Wire entry for this enclosure is between two pieces of soft
foam. If the adjustable plate is slid back, a gap develops
between the foam pieces. Otherwise, the foam acts as a loose
gasket around the wires.
Stationary metal front bottom plate
Two pieces of soft foam taped to adjacent metal plates
Overlapping metal bottom plate (slightly adjustable)
Stationary metal back bottom plate