Rockwell Automation 20D PowerFlex 700H and 700S Frame 9...14 Drives - Manual (Page 149)

Rockwell Automation Publication PFLEX-IN006E-EN-P - July 2013 149
Frame 14 Mechanical Installation Chapter 10
Power Wiring To access the power terminals, you must first remove the protective screens (on
NEMA/UL Type 1 and Type 12 enclosures), air flow plate and protective covers
from the inverter units. These steps are detailed below.
Remove the Protective
Covers from the Inverter
Units Remove the Protective Screens
To access the power terminals, you must first remove the protective screens from
the inverter units.
• Remove the screws that secure the protective screens to the inverter units
and remove the screens.
Remove screws
and screens