Rockwell Automation 20D PowerFlex 700H and 700S Frame 9...14 Drives - Manual (Page 76)

76 Rockwell Automation Publication PFLEX-IN006E-EN-P - July 2013
Chapter 6 Frame 10 Mechanical Installation
Lifting and Mounting Frame
10 Drives See the Lifting and Mounting PowerFlex 700S and 700H Drives, Frames 10…14,
Installation Instructions, publication
PFLEX-IN005 , for detailed instructions.
These instructions are shipped with the drive. When you have completed the
instructions in PFLEX-IN005, continue with the installation as directed below.
Remove the Protective
Covers Move the Control Frame
To gain access to the power wiring terminals, airflow plate and protective covers
you may need to move the control frame out of the way. If you do not need to
move the control frame, continue with Remove the Airflow Plate on page
77 .
Task Description
Loosen the T8 Torx-head screws that secure the control frame to the drive enclosure (remove screws on
early frame 10 drives).
Swing the control frame out and away from the power structure.
A
B
A
B
A
Frame 10 drives, from early production runs, have holes instead of
slots for these screws. You must completely remove the screws from
these drives in order to swing-open the control frame.
or