Rockwell Automation 20D PowerFlex 700H and 700S Frame 9...14 Drives - Manual (Page 113)

Rockwell Automation Publication PFLEX-IN006E-EN-P - July 2013 113
Frame 12 Mechanical Installation Chapter 8
Disconnect the Small Capacitors from the Input Terminals
Follow the steps below to disconnect the small capacitors from the input
terminals.
IMPORTANT It is not necessary to remove the power wiring from the terminals in order to
insulate the capacitor leads.
Task Description
Remove the screws and lock washers that secure each of the three capacitor supply wires to the input power
terminals.
Insulate the capacitor leads and leave disconnected.
Install and tighten the screws and lock washers only.
IMPORTANT Do not re-install the capacitor leads.
A
B
C
L1 L2 L3
Capacitor
Insulator
Capacitor lead - leave
disconnected
Input power terminal
A B
C
Front View of Input
Power Terminals
Side View of Input
Power Terminals