Analog i/o configuration, Hardware enable circuitry, Analog i/o configuration hardware enable circuitry – Rockwell Automation 20D PowerFlex 700H and 700S Frame 9...14 Drives User Manual
Page 36
36
Rockwell Automation Publication PFLEX-IN006E-EN-P - July 2013
Chapter 2
Control Wiring for PowerFlex 700H Drives
Analog I/O Configuration
See
Figure 6
on page
33
for the location of the jumpers indicated in the table
below.
Table 11 - I/O Configuration
Hardware Enable Circuitry
By default, the user can program a digital input as an Enable input. The status of
this input is
interpreted by drive software. If the application requires the drive to be
disabled
without software interpretation, a “dedicated” hardware enable
configuration can be utilized. This is done by removing jumper J5 (see table
below) and wiring the enable input to digital input 6. Verify that parameter 366
[Digital In6 Sel] is set to “1-Enable”.
Table 12 - Hardware Enable Configuration
IMPORTANT
Analog I/O must be configured through programming, as well as the jumpers
shown below. See the PowerFlex 700H Adjustable Frequency AC Drive
Programming Manual, publication
Signal
Jumper
Setting
Analog
Inputs
J1 (Analog In 1)
J2 (Analog In 2)
0…20 mA
0…10V
±
10V
Analog
Outputs
J3 (Analog Out 1)
J4 (Analog Out 2)
0…20 mA
0…10V
±
10V
Signal
Jumper
Setting
Hardware
Enable
J5
Hardware Enable
Input Programmable (No Hardware Enable)
C D
B
A
J1
J2
C D
B
A
C D
B
A
J1
J2
C D
B
A
C D
B
A
J1
J2
C D
B
A
C D
B
A
J3
J4
C D
B
A
C D
B
A
J3
J4
C D
B
A
C D
B
A
J3
J4
C D
B
A
B
A
J5
B
A
J5