Rockwell Automation 20D PowerFlex 700H and 700S Frame 9...14 Drives - Manual (Page 82)

82 Rockwell Automation Publication PFLEX-IN006E-EN-P - July 2013
Chapter 6 Frame 10 Mechanical Installation
Insulate Terminal X4 on the Rectifier Circuit Board
Follow the steps below to insulate terminal X4 on the rectifier circuit board (see
Figure 25 on page 80 for rectifier board location).
Task Description
Remove the screw from the X4 connection on the rectifier circuit board.
Insulate the top and bottom of the X4 connection on the rectifier circuit board.
IMPORTANT Do not install the screw and washer that was removed from this connection.
A
B
X1
X4
X41
X1
X4
X41
A
B
Rectifier Circuit Board
Side View of Power Structure