Rockwell Automation 20D PowerFlex 700H and 700S Frame 9...14 Drives User Manual
Rockwell Automation Equipment
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- PowerFlex 700H and 700S AC Drives, Frames 9...14, Installation Instructions
- Summary of Changes
- Table of Contents
- Preface
- Chapter 1 - General Installation Information
- Chapter 2 - Control Wiring for PowerFlex 700H Drives
- Chapter 3 - Control Wiring for PowerFlex 700S Drives with Phase II Control
- Chapter 4 - Communication Options
- Chapter 5 - Frame 9 Mechanical Installation
- Chapter 6 - Frame 10 Mechanical Installation
- Chapter 7 - Frame 11 Mechanical Installation
- Chapter 8 - Frame 12 Mechanical Installation
- Chapter 9 - Frame 13 Mechanical Installation
- Chapter 10 - Frame 14 Mechanical Installation
- Minimum Mounting Clearances
- Operating Temperatures
- Dimensions
- Lifting and Mounting Frame 14 Drives
- Ungrounded, High Resistive Ground or Grounded B Phase Delta Installations
- Remove the Protective Covers from the Converter Unit(s)
- Remove the Protective Screens
- Move the Control Frame
- Remove the Airflow Plate(s)
- Remove the Protective Covers
- Installation on an Ungrounded Distribution System or High Resistive Ground
- Installation on a Grounded B Phase Delta System
- Move the Common Mode Jumper(s) to the Disconnected Position
- Insulate Terminal X4 on the Rectifier Circuit Board
- Power Wiring
- Remove the Protective Covers from the Inverter Units
- Frame 14 Circuit Breakers
- Appendix A - Specifications
- Appendix B - PowerFlex 700S Stegmann Hi-Resolution Encoder Feedback Option
- Appendix C - PowerFlex 700S Resolver Feedback Option Card
- Appendix D - PowerFlex 700S Multi-Device Interface (MDI) Option Card
- Appendix E - Instructions for ATEX Approved PowerFlex 700H Drives in Group II Category (2) Applications with ATEX Approved Motors
- Appendix F - History of Changes
- Index
- Back Cover