Rockwell Automation 20D PowerFlex 700H and 700S Frame 9...14 Drives - Manual (Page 127)

Rockwell Automation Publication PFLEX-IN006E-EN-P - July 2013 127
Frame 13 Mechanical Installation Chapter 9
Insulate Terminal X4 on the Rectifier Circuit Board
Follow the steps below to insulate terminal X4 on the rectifier circuit board for
each converter unit (see
Figure 50 on page 123 for rectifier board location).
Task Description
Remove the screw from the X4 connection on the rectifier circuit board.
Insulate the top and bottom of the X4 connection on the rectifier circuit board.
IMPORTANT Do not install the screw and washer that was removed from this connection.
A
B
X1
X4
X41
X1
X4
X41
Rectifying Circuit
Board
Jumper
Side View of Rectifying
Structure
A B