Rockwell Automation 20D PowerFlex 700H and 700S Frame 9...14 Drives - Manual (Page 97)

Rockwell Automation Publication PFLEX-IN006E-EN-P - July 2013 97
Frame 11 Mechanical Installation Chapter 7
Power Wiring AC Input Wiring
The table below identifies which frame 11 drives contain only one rectifying
module and which frame 11 drives contain two rectifying modules. Drives with
one rectifying module contain only one set of input power terminals. Drives with
two parallel rectifying modules contain two sets of input power terminals--you
must supply power to both sets of input terminals on these drives. There are
several methods for accomplishing this. Each of these methods is shown below.
Figure 33 - AC Wiring Example: Two Fuses per Phase
Voltage Class Amps Number of
Rectifiers
400/480V AC Input 590 2
650 2
730 2
600/690V AC Input 460 1
502 1
590 2
IMPORTANT Parallel wiring must have the same cable dimensions, type and routing. Non-
symmetrical wiring may cause unequal loading between the converters and
reduce the drive’s ability to deliver current to the motor.
1L1 1L2 1L3 2L1 2L2 2L3
L1 L2 L3
AC Input Power Terminals Inside Drive
AC Input Power Wiring, Fuses, and Disconnect
Device Provided by Customer