Hypertherm Powermax105 Service Manual - Manual (Page 202)

Power SuPPly ComPonent rePlaCement
9-4
powermax
105 Service Manual
 Step task Page
 1. Disconnect the power and gas supply 9-16
 2. Remove the power supply cover 9-21
 3. Set the voltage divider board 9-26
 4. Connect the machine interface cable 9-27
 5. Install the power supply cover 9-92
Installing the machine interface cable
Kit # 228350, 228351
 Step task Page
 1. Disconnect the power and gas supply 9-16
 2. Remove the power supply cover 9-21
 3. Remove the component barrier 9-21
 4. Remove the end panel bracket 9-22
 5. Install the RS485 serial interface cable 9-28
 6. Install the end panel bracket 9-90
 7. Install the component barrier 9-91
 8. Install the power supply cover 9-92
Installing the RS485 serial interface cable
Kit # 228539
 Step task Page
 1. Disconnect the power and gas supply 9-16
 2. Remove the power supply cover 9-21
 3. Remove the component barrier 9-21
 4. Install the machine interface cable with voltage divider board 9-23
 5. Set the voltage divider board 9-26
 6. Install the component barrier 9-91
 7. Install the power supply cover 9-92
Installing the machine interface cable with voltage divider board
Kit # 228884