Hypertherm Powermax105 Service Manual - Manual (Page 288)

Power SuPPly ComPonent rePlaCement
9-90
powermax
105 Service Manual
Install the end panel bracket
1. Align the end panel bracket positioning posts with the holes in the top of the front and rear end panels. Make sure
the end panel bracket mounting tabs are positioned on the fan side of the power supply.
2. Push the end panel bracket straight down onto the power supply.
3. Tighten the two end panel bracket mounting screws to 11.5 kg cm (10 in.-lbs).
Positioning posts Positioning posts
Front end panel Rear end panel
Mounting tabs
Mounting screws