Hypertherm Powermax105 Service Manual - Manual (Page 29)

SpecificationS
powermax
105 Service Manual 1-11
Symbols and markings
Your Hypertherm product may have one or more of the following markings on or near the data plate. Due to differences
and conflicts in national regulations, not all marks are applied to every version of a product.
S mark symbol
The S mark symbol indicates that the power supply and torch are suit able for operations carried out in en vi ron ments with
increased hazard of elec tri cal shock per IEC 60974-1.
CSA mark
Hypertherm products with a CSA mark meet the United States and Canadian regulations for product safety. The products
were evaluated, tested, and certified by CSA-International. Alternatively the product may have a mark by one of the other
Nationally Recognized Testing Laboratories (NRTL) accredited in both the United States and Canada, such as Underwriters
Laboratories, Incorporated (UL) or TÜV.
CE marking
The CE marking signifies the manufacturer’s declaration of conformity to applicable European directives and standards.
Only those versions of Hypertherm products with a CE marking located on or near the data plate have been tested for
compliance with the European Low Voltage Directive and the European Electromagnetic Compatibility (EMC) Directive.
EMC filters needed to comply with the European EMC Directive are incorporated within versions of the product with a
CE marking.
goSt-R mark
CE versions of Hypertherm products that include a GOST-R mark of conformity meet the product safety and EMC
requirements for export to the Russian Federation.
c-tick mark
CE versions of Hypertherm products with a c-Tick mark comply with the EMC regulations required for sale in Australia and
New Zealand.
s
CCC mark
The China Compulsory Certification (CCC) mark indicates that the product has been tested and found compliant with
product safety regulations required for sale in China.
UkrSEPRo mark
CE versions of Hypertherm products that include a UkrSEPRO mark of conformity meet the product safety and EMC
requirements for export to the Ukraine.
Noise levels
Acceptable noise levels as defined by national and local codes may be exceeded by this plasma system. Always
wear proper ear protection when cutting or gouging. Any noise measurements taken are dependant on the specific
environment in which the system is used. See also Noise can damage hearing in the Safety and Compliance Manual
included with your system. Specific information by product can be found in the Hypertherm downloads library at:
https://www.hypertherm.com/
Click Downloads library, select a product from the Product Type drop-down menu, select “Regulatory” from the
Category drop-down menu, and select “Acoustical Noise Data Sheets” from the Sub Category drop-down menu.